Can you give a brief introduction about the structure of the NMOS ?
Analog Mixed Signal Design Engineer Interview Questions
87 analog mixed signal design engineer interview questions shared by candidates
What was your contribution to this project? Explain how the project works.
Started with combinational and sequential circuits. D flip flop Thesis related questions RC low pass filter. Metastability. Difference between system verilog And UVM
Strong arm latch. Describe output waveform from the initial phase to the final state
R-RC-R circuit. What is the step response?
RF: Receiver blocks, Capacitor behavior in AC/DC circuits, Filters, intermodulation.
Mostly very basic Device Physics questions. Not very complicated and some of the questions were: 1. Describe the operation of NMOS and PMOS, 2. What is body effect? How does it affect the gate voltage. 3. Describe the operating regions of NMOS transistor 4. If gate voltage is 2V and drain voltage is is 2V what is the source voltage? 5. What factors affect threshold voltage? Explain them 6. What is channel length modulation?
Viewing 81 - 90 interview questions