Questions on C and details of the previous projects carried out
Designer Interview Questions
111,202 designer interview questions shared by candidates
Most of the technical questions focused on power supply design. For this position this is a one of the more difficult tasks so they want to know how switching regulators work and different trade offs involved.
What are the different ways you can you tell if this part is steel or aluminium.
Questions that popped out as I can remember. 1) A cube (1-1-1m) of ice in a room (50C) sitting on a wooden table. the ice is 1m away from the walls around it's 4 sides, except for 1 side is 30cm away. You're given 2 insulating blankets (1m by 1m) that can be used to cover the ice block. The goal is to keep the ice in solid form as long as possible. Where would you put the blankets? 2) 2 rectangular beams, one is Aluminum a by 2b cross-section one is Steel a by b cross-section. If you were to climb a mountain and find these two sticking out on a spot where you need to rest, which one would you latch on to? 3) Interviewee shows a plastic part and asks: How do you think I built this part? What other ways can you think of this part could have been done?
What is the difference between stress and pressure Difference between axle and shaft. What is CATIA. Expand. and other questions related to CATIA
What makes you a superstar.
If you had a hot coffee mug in a room, what information would you need to derive the heat transfer equations?
Do you have any after effects and animation experience?
What will be the output if 100 volt DC is fed into 1:2 Transformer ?
if your design is not liked, what will do?
Viewing 51 - 60 interview questions