You're shrunk and put in a blender, how will you get out ?
Hardware Engineer Internship Interview Questions
5,137 hardware engineer internship interview questions shared by candidates
Basic questions
solve op-amp questions
What do you know about PCBs
They inquired about my work eligibility and when I can start.
- No introduction asked - What are you passionate about? - Where do you see yourself after Btech? - First question was from the Digital Electronics section of the written round that I had answered incorrectly back then. - - Second question was about DFS traversal. They once again showed a question from the written round where they had asked me to state the traversal path. - A question on computer architecture that could be solved without prior knowledge of the same. - What do you know about Full Adders? - What logic gates can you implement using Full adders? ( I was unable to answer this right away) - Implement AND Gate using Full Adder ( Hint: Make Cin =1) - Implement OR Gate using Full Adder - Some VLSI numericals
2 technical interview focusing on resume and basic questions on setup time, hold time, how can you overcome it.Basic power related questions.
Digital Logic Design VLSI DFT Coding Probability
phone interview 1 - cache related question (extending the question solved at career fair, the guy had my paper with him) Explain cache replacement policies. which cache replacement policy is better ? show it by giving some memory accesses. Virtual memory question (extension of career fair question) Explain virtual memory mechanism phone interview 2 C++ coding questions write a swap function write Fibonacci function (recursively and non recursively) Data structure questions explain linked list can you code it (I told I dont know how to) phone interview 3 Test related questions Do you know TAP controller ? (I didnt at that time) if there are n inputs and m outputs how many patterns will be needed to test the circuit completely? (I replied 2^n :p ) explain stuck at fault models (I didnt know this either) he explained stuck at model to me and ask me how will you find if the wire is suck at 0 or not didnt know the answer but tried explaining my approach (which was correct as I learnt later activate and propagate).
a: Basics of Digital circuit? b:Basics of High speed design and PCB?
Viewing 2441 - 2450 interview questions