Can you explain 5 level of working of an Inverter
Physical Design Interview Questions
3,254 physical design interview questions shared by candidates
What do you know about physical design in vlsi?
6T SRAM working
How slack effects the frequency in design flow.?
He asked me about my design project which I did during my Masters, Timing analysis, Flipflops, PD Flow
What was the major challenge you faced while working on this project?
describe the syn/apr process setup/hold time violation and fix
Describe your previous work
STA, CTS, Floor planning, Logic Circuits, PNR 1. What is OCV and derate factors 2. Calculation of setup and hold slack (Given values, Thold, Tsetup, Tlogic, derate factors) 3. How to reduce setup violations and hold violations? 4. Difference between H-tree and Mesh? 5. Techniques to reduce clock power? 6. Low power design techniques 7. What is Multi Bit FF? 8. Draw basic logic gates (And) using NOR (NAND) gates? 9. Crosstalk glitches? 10. Placement of macros questions 11. How to calculate channel spacing between macros/ 12. SRAM design questions 13. Physical only cells- Tap cells, Tie cells use and where do we place them 14. How Delay of a net/cell changes with VDD/ 15. Capacitance and Resistance of wire effects on delay and how to reduce it? 16. How to reduce static, Dynamic, short -circuit power? 17. Where to use LVT, HVT cells? 18. Difference between local skew and global skew? 19. Verilog Coding question- Synchronous and Asynchronous DFF 20. What is the use of End cap cells and Decap cells?
Questions mainly based on resume and a few STA questions, questions based on CMOS.
Viewing 3241 - 3250 interview questions